Xfce Panel Plugins - en to en_GB translation catalogue (27 entries)

en: 1 millimeter is one thousandth of a meter - the fundamental unit of length in the International System of Units -, or approximately 0.04 inches.
en_GB: 1 millimetre is one thousandth of a metre - the fundamental unit of length in the International System of Units -, or approximately 0.04 inches.

en: <tt><small>Moonrise: The moon never rises this day.</small></tt>
en_GB: <tt><small>Moonrise: The Moon never rises this day.</small></tt>

en: <tt><small>Moonset: The moon never sets this day.</small></tt>
en_GB: <tt><small>Moonset: The Moon never sets this day.</small></tt>

en: <tt><small>Sunrise: The sun never rises this day.</small></tt>
en_GB: <tt><small>Sunrise: The Sun never rises this day.</small></tt>

en: <tt><small>Sunset: The sun never sets this day.</small></tt>
en_GB: <tt><small>Sunset: The Sun never sets this day.</small></tt>

en: Available icon themes are listed here. You can add icon themes to $HOME/.config/xfce4/weather/icons (or the equivalent directory on your system). Information about how to create or use icon themes can be found in the README file. New icon themes will be detected every time you open this config dialog.
en_GB: Available icon themes are listed here. You can add icon themes to $HOME/.config/xfce4/weather/icons (or the equivalent directory on your system). Information about how to create or use icon themes can be found in the README file. New icon themes will be detected every time you open this config dialogue.

en: Font and color:
en_GB: Font and colour:

en: For locations outside Norway the elevation model that's used by the met.no webservice is not very good, so it's usually necessary to specify the altitude as an additional parameter, otherwise the reported values will not be correct.
    
    The plugin tries to auto-detect the altitude using the GeoNames webservice, but that might not always be correct too, so you can change it here.
    
    Altitude is given in meters above sea level, or alternatively in feet by changing the unit on the units page. It should match the real value roughly, but small differences will have no influence on the weather data. Inside Norway, this setting has no effect at all.
en_GB: For locations outside Norway the elevation model that's used by the met.no webservice is not very good, so it's usually necessary to specify the altitude as an additional parameter, otherwise the reported values will not be correct.
    
    The plug-in tries to auto-detect the altitude using the GeoNames webservice, but that might not always be correct too, so you can change it here.
    
    Altitude is given in meters above sea level, or alternatively in feet by changing the unit on the units page. It should match the real value roughly, but small differences will have no influence on the weather data. Inside Norway, this setting has no effect at all.

en: If the chosen location is not in your current timezone, then it is necessary to <i>put</i> the plugin into that other timezone for the times to be shown correctly. The proper timezone will be auto-detected via the GeoNames web service, but you might want to correct it if necessary.
    Leave this field empty to use the timezone set by your system. Invalid entries will cause the use of UTC time, but that may also depend on your system.
en_GB: If the chosen location is not in your current timezone, then it is necessary to <i>put</i> the plug-in into that other timezone for the times to be shown correctly. The proper timezone will be auto-detected via the GeoNames web service, but you might want to correct it if necessary.
    Leave this field empty to use the timezone set by your system. Invalid entries will cause the use of UTC time, but that may also depend on your system.

en: Kilometers per hour (km/h)
en_GB: Kilometres per hour (km/h)

en: Meter per second is <i>the</i> unit typically used by meteorologists to denote wind speeds.
en_GB: Metre per second is <i>the</i> unit typically used by meteorologists to denote wind speeds.

en: Meters (m)
en_GB: Metres (m)

en: Meters per second (m/s)
en_GB: Metres per second (m/s)

en: Millimeters (mm)
en_GB: Millimetres (mm)

en: Please change location name to your liking and correct alltitude and timezone if they are not auto-detected correctly.
en_GB: Please change the location name to your liking and correct altitude and timezone if they are not auto-detected correctly.

en: Please set a location in the plugin settings.
en_GB: Please set a location in the plug-in settings.

en: The English word <i>inch</i> comes from Latin <i>uncia</i> meaning <i>one-twelfth part</i> (in this case, one twelfth of a foot). In the past, there have been many different standards of the inch with varying sizes of measure, but the current internationally accepted value is exactly 25.4 millimeters.
en_GB: The English word <i>inch</i> comes from Latin <i>uncia</i> meaning <i>one-twelfth part</i> (in this case, one twelfth of a foot). In the past, there have been many different standards of the inch with varying sizes of measure, but the current internationally accepted value is exactly 25.4 millimetres.

en: The amount of rain, drizzle, sleet, hail, snow, graupel and other forms of water falling from the sky over a specific period.
    
    The values reported by met.no are those of precipitation in the liquid state - or in other words: of rain -, so if snow is expected (but not sleet), then the amount of snow will be <i>guessed</i> by multiplying the original value by a ratio dependent on the air temperature:
    
    <tt><small>                   T &lt; -11.1 °C (12 °F) =&gt; 1:12
    -11.1 °C (12 °F) &lt; T &lt;  -4.4 °C (24 °F) =&gt; 1:10
     -4.4 °C (24 °F) &lt; T &lt;  -2.2 °C (28° F) =&gt; 1:7
     -2.2 °C (28 °F) &lt; T &lt;  -0.6 °C (31 °F) =&gt; 1:5
     -0.6 °C (31 °F) &lt; T                    =&gt; 1:3
    
    </small></tt>Example: If temperature is -5 °C (12 °F), then snow density will be low and a rain to snow ratio of 1:10 will be used for calculation. Assuming the reported value is 5 mm, then the calculated amount of snow precipitation is 50 mm.
    
    <b>Note</b>: While air temperature is an important factor in this calculation, there are other influencing factors that the plugin doesn't know about like the type of snow and ground temperature. Because of that, these rules will only lead to rough estimates and may not represent the real amount of snow.
en_GB: The amount of rain, drizzle, sleet, hail, snow, graupel and other forms of water falling from the sky over a specific period.
    
    The values reported by met.no are those of precipitation in the liquid state - or in other words: of rain -, so if snow is expected (but not sleet), then the amount of snow will be <i>guessed</i> by multiplying the original value by a ratio dependent on the air temperature:
    
    <tt><small>                   T &lt; -11.1 °C (12 °F) =&gt; 1:12
    -11.1 °C (12 °F) &lt; T &lt;  -4.4 °C (24 °F) =&gt; 1:10
     -4.4 °C (24 °F) &lt; T &lt;  -2.2 °C (28° F) =&gt; 1:7
     -2.2 °C (28 °F) &lt; T &lt;  -0.6 °C (31 °F) =&gt; 1:5
     -0.6 °C (31 °F) &lt; T                    =&gt; 1:3
    
    </small></tt>Example: If temperature is -5 °C (12 °F), then snow density will be low and a rain to snow ratio of 1:10 will be used for calculation. Assuming the reported value is 5 mm, then the calculated amount of snow precipitation is 50 mm.
    
    <b>Note</b>: While air temperature is an important factor in this calculation, there are other influencing factors that the plug-in doesn't know about like the type of snow and ground temperature. Because of that, these rules will only lead to rough estimates and may not represent the real amount of snow.

en: The foot per second (pl. feet per second) in the imperial unit system is the counterpart to the meter per second in the International System of Units.
en_GB: The foot per second (pl. feet per second) in the imperial unit system is the counterpart to the metre per second in the International System of Units.

en: The meter is the fundamental unit of length in the International System of Units. Originally intended to be one ten-millionth of the distance from the Earth's equator to the North Pole at sea level, its definition has been periodically refined to reflect growing knowledge of metrology (the science of measurement).
en_GB: The metre is the fundamental unit of length in the International System of Units. Originally intended to be one ten-millionth of the distance from the Earth's equator to the North Pole at sea level, its definition has been periodically refined to reflect growing knowledge of metrology (the science of measurement).

en: The pascal, named after mathematician, physicist and philosopher Blaise Pascal, is a SI derived unit and a measure of force per unit area, defined as one newton per square meter. One standard atmosphere (atm) is 1013.25 hPa.
en_GB: The pascal, named after mathematician, physicist and philosopher Blaise Pascal, is a SI derived unit and a measure of force per unit area, defined as one newton per square metre. One standard atmosphere (atm) is 1013.25 hPa.

en: The sun never rises and sets at %s.
en_GB: The Sun never rises and sets at %s.

en: The sun rises at %s and never sets.
en_GB: The Sun rises at %s and never sets.

en: The torr unit was named after the physicist and mathematician Evangelista Torricelli who discovered the principle of the barometer in 1644 and demonstrated the first mercury barometer to the general public. A pressure of 1 torr is approximately equal to one millimeter of mercury, and one standard atmosphere (atm) equals 760 Torr.
en_GB: The torr unit was named after the physicist and mathematician Evangelista Torricelli who discovered the principle of the barometer in 1644 and demonstrated the first mercury barometer to the general public. A pressure of 1 torr is approximately equal to one millimetre of mercury, and one standard atmosphere (atm) equals 760 Torr.

en: There may be problems with some themes that cause the scrollbox text to be hardly readable. If this is the case or you simply want it to appear in another color, then you can change it using this button. Middle-click on the button to unset the scrollbox text color.
en_GB: There may be problems with some themes that cause the scrollbox text to be hardly readable. If this is the case or you simply want it to appear in another colour, then you can change it using this button. Middle-click on the button to unset the scrollbox text colour.

en: This reports the high-level cloud cover in percent. According to WMO definition, high-level clouds can be found in altitudes of 8,000 to 15,000 m (26,000 to 49,000 ft), or 10,000 m-18,000 m (33,000-59,000 ft) at the equator, where temperatures are so low that they are mainly composed of ice crystals. While typically thin and white in appearance, they can be seen in a magnificent array of colors when the sun is low on the horizon.
en_GB: This reports the high-level cloud cover in percent. According to WMO definition, high-level clouds can be found in altitudes of 8,000 to 15,000 m (26,000 to 49,000 ft), or 10,000 m-18,000 m (33,000-59,000 ft) at the equator, where temperatures are so low that they are mainly composed of ice crystals. While typically thin and white in appearance, they can be seen in a magnificent array of colours when the sun is low on the horizon.

en: meters
en_GB: metres
